A Comprehensive Guide to Wiring your Honeywell RTH3100C Thermostat

Heating, ventilation and air-conditioning systems are a costly but necessary part of life. In order to ensure that your system is functioning correctly and properly distributing the heat or cool air throughout your home, it’s important to have it wired appropriately.

The Honeywell RTH3100C is a commonly used thermostat or heat pump controller, allowing the user to program each day’s temperature settings and operate their HVAC system automatically. Though the process of wiring a this thermostat can look intimidating at first glance, by following the steps outlined in this article, you will be able to avoid any major installation errors.

Wiring Terminals and Connections Required

Before you begin wiring your Honeywell RTH3100C, it’s essential to understand the type of wires used in the thermostat and how they should be connected. Each terminal has its own purpose, so this section will explain the purpose of each, the labels on the terminal block, and the type of wire needed for the connections.

The specific terminals required for this thermostat are:

Y = Cooling/Compressor

G = Fan

Rh = Power

W = Heating

R = Auxiliary or Emergency Heat

C = Common Wire/24VAC power

The terminals of the Honeywell RTH3100C should be labeled clearly on the side of the thermostat case, making it easy to identify which wires need to be connected. However, the wire-gauge used in different HVAC systems can vary, so you may need to refer to the instruction manual provided with your thermostat in order to check the specific wire requirements.

Required Tools

In order to successfully wire your Honeywell RTH3100C, you will need a few tools to make sure the job is done correctly. These include:

Wire cutters and strippers

Electrical tape

Screwdriver

Wire labels

Make sure you have these tools available before you start, in order to make the wiring process as easy and safe as possible.

Step By Step Wiring Diagram for Honeywell RTH3100C

Once you have identified the correct wires and made sure you have all the correct tools, follow the steps outlined in the diagram below in order to wire your Honeywell RTH3100C:

Step	Instructions
1.	Connect the common (C) wire to the common terminal.
2.	Connect the heating (W) wire to the W terminal.
3.	Connect the cooling (Y) wire to the Y terminal.
4.	Connect the auxiliary (R) wire to the R terminal.
5.	Connect the fan (G) wire to the G terminal.
6.	Connect the power (Rh) wire to the Rh terminal.

Placing the Thermostat

Once the wiring has been completed, the next step is to attach the Honeywell RTH3100C thermostat to the wall in a convenient location. It should ideally be somewhere where you can adjust the temperature easily, such as near an entrance.

Make sure the thermostat is level, secure it to the wall using the screws provided, and then plug in the transformer and confirm the power is on. The thermostat should now be ready to use.

Final Check and Programming

Once you have wired and installed your Honeywell RTH3100C, it’s important to do a final check to make sure everything is working properly. This includes checking that all of the wiring connections are tight and secure, and making sure there is adequate power supply to the thermostat.

Once that is done, you can program it according to your needs. The Honeywell RTH3100C has 7-day programming with 4 settings for each day and multiple temperature sensing options. You can also take advantage of energy-saving features such as the adjustable cycle rate, which alters the thermostat's cycling of the furnace or air conditioning based on the minimum temperature fluctuation specified by the user.

Now that your Honeywell RTH3100C is set up and programmed, you can rest assured knowing your HVAC system is functioning efficiently.

Above all though, remember to follow all safety protocols throughout the wiring and installation process. If you encounter any difficulties, don’t hesitate to contact a qualified electrician.

Digital Non Programmable Heat Cool Pump Thermostat Honeywell Home